| Panelglide Display Systems Seemless
Exhibit Systems - Set-up Instructions
|
| |
| 1. PANEL ASSEMBLY |
| 1-Do NOT unfold panels. |
| 2-Stack mid stripe sections (if included) onto
bottom section by inserting nylon pins into bottom section as shown. |
| 3-Stack top section onto the mid=stripe (or bottom
section if there is no mid stripe) in the same manner. |
 |
| Panels can be positioned by holding bottom of display
and fanning out the panels as indicated by the arrows. Never straighten the
system all the way out. You must have at least two panels angled 45 degrees
or more to the rest of the system in order to maintain stability. |
| |
| 2. CURVE ASSEMBLY |
| To assemble curves, swing aluminum brackets so that
they are at a right angle to the curve (as shown). Then insert the nylon
pin from the bracket into the opposite bracket and secure with the velcro hook
tape on the outside of these brackets. |
 |
| |
| 3. ATTACHING CURVES |
| Attached curves to panels by sliding open-end of
curved unit over the edge of the bottom panel. It may be helpful to slide
it in a downward motion. Middle curved sections may be attached in the same
manner, taking care to insert pin into the corresponding hold of the bottom
unit and tucking in flap behind bottom curved end unit. Repeat this procedure
for the top end curve section. Repeat on other side of unit. |
 |
| |
| 4. ATTACHING COMPONENTS |
| ALCOVE COUNTER INSTRUCTIONS |
 |
After setting up display system as shown, slip the four shelf
brackets between mid-stripe and lower panel as shown. Joint the two pieces of
the countertop by fastening spring latches. Place countertop assembly on shelf
brackets. Attach doors beneath countertop at opposite ends. Place modesty panel
between sets of doors. |
SHELVING
Aluminum shelving fits in between panels and comes either slanted or
straight. Also available is plastic shelving which attaches to unit with
velcro hook tape.
|
Stabilizer bars and lights fit over the top of the display. Stabilizer
bars are plastic channels that help keep the display stabile at the hinges
where a flat backwall is desired.
|
|
HEADERS
(back side shown below)
Headers that are 60" or longer are in two parts. Connect the header pieces
by latching them together from the back. To place on display, slide pins
behind the wall of panels and position header as far forward or back as
you need. (The angle of the panels will affect this.)
|
|
| |
| PENINSULA COUNTER INSTRUCTIONS |
 |
- Attach front quarter round panels to each other with the wood spine provided.
- Add back (flat section) to joined quarter rounds by sliding this panel
(40"h x 19"w) into u channels.
- Slip two shelf brackets between mid stripe and lower panel on display
backwall.
- Position half-round and place countertop to rest on brackets and half
round.
* If included, attached the modesty panel beneath the countertop. On the
opposite side, attach the door and 7" fill panel.
|
| |
 |
Headers (both halves) should be placed face to face
inside the foam tray provided.
Foam Tray
Cardboard
Curve (place fabric side down)
Curve (place fabric side down)
Curve (place fabric side down)
Curve (place fabric side down)
Top panels (accordian folded)
Case
|
